Continue to Site

Welcome to MCAD Central

Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.

"Thickness not defined"

bkeavney

New member
I have been scrubbing the geometry of a complex part in preparation for meshing. The part was built exclusively with solid modeling features (no surface bodies). I used the "delete face" and "extend surface" features in a few places to connect adjacent planer surfaces. Now, when I attempt to mesh, I get the message "Thickness is not defined for one or more shells." SolidWorks recognizes only one solid body & no surface bodies in the part.

Any ideas?

Brendan
 
you should not see any surface on the analysis tree.


if they are there, right-click on them then select "exclude from analysis"


remark: hiding them is not enough, you must exclude them.
 

Sponsor

Articles From 3DCAD World

Back
Top