Hello
I have created a part for an assembly but when inserted it gets scaled up approximatly X10.
I have checked that the units are the same and both are set to 'mmgs'.
It also wont let me edit it in the assembly.
I am reticent to change the dimesions in the part file as this will give me out of scale drawings.
Any help would be much apprieciated.
Thanks B
I have created a part for an assembly but when inserted it gets scaled up approximatly X10.
I have checked that the units are the same and both are set to 'mmgs'.
It also wont let me edit it in the assembly.
I am reticent to change the dimesions in the part file as this will give me out of scale drawings.
Any help would be much apprieciated.
Thanks B