I wondered if anyone else has had problems with mirroring a sheetmetal part?
Not in the same drawing but clicking insert and half way down the pull down there is a tool called mirror part. I wanted to create a mirrored part with no links to the original so i clicked the tick button to say break link to part.
The problem is it says it cannot create a lot of the features and copies it as a dumb solid with none of the sheetmetal features. Is there anyway of doing this to keep the features?
I tried it with some complex extruded items with no problem it was just sheetmetal components.
Andy
Not in the same drawing but clicking insert and half way down the pull down there is a tool called mirror part. I wanted to create a mirrored part with no links to the original so i clicked the tick button to say break link to part.
The problem is it says it cannot create a lot of the features and copies it as a dumb solid with none of the sheetmetal features. Is there anyway of doing this to keep the features?
I tried it with some complex extruded items with no problem it was just sheetmetal components.
Andy