Continue to Site

Welcome to MCAD Central

Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.

Quick Sheet Metal Help

QSQCaito

New member
Hello guys, wonderful forum. That's why I'm posting again, need some help with shheetmetal.


[url]http://www.4shared.com/file/54148350/690cbf94/error_chapa.ht ml?dirPwdVerified=611c6210[/url]

I want to put sheetmetal in 3 parts. One where you can see it in the picture, where I created a plane, and in between in the upper part. I can put sheetmetal in any of the 3, but then anywhere else. An error appears, translated it would be something like "the plane of the sketch for the flap must match up with the superior or inferior part of the base of the solid"


I really don't understand what this means, nor what solid is he talking about. I'll leave you the solid file in case you want to see it in your language.






Thanks a lot in advance!

PS: slwrks file
[url]http://www.4shared.com/file/54150040/8a8531d3/_2__Chasis_Cob ra_FORUM.html?dirPwdVerified=611c6210 [/url]
 
I try help you but... I use an older SW (2007)so I can't open your file.


I see the picture and I don't understand why you use the planes. Create sheet metal parts (or configurations of the same part) and use mates to position this parts in the assembly. If I understand ok, the picture is a frame created from the tubes. Use the tubes axes to mate the walls.


Good luck !


Mihail
 

Sponsor

Articles From 3DCAD World

Back
Top