microsoft forms error

Hi all,

I am new to Solidworks (coming from Pro Engineer) and have a question. When I open Solidworks, it opens fine. But when I open up any object/drawing/part for the first time that session I get this error:

Microsoft Forms
! Could not load an object because it is not available on this machine.

Can anyone help.

Sounds like a bad install. Go to your control panel, add/remove programs and click on the solidworks program, install/modify/remove/repair,indicate REPAIR. Have your disk ready. This should solve the issue.





Good Luck,
Edited by: ttraser

Thank you!!! That is exactly what it was. It didn't work just to repair, but I
did a uninstall, reinstall.

THANKS AGAIN!

Thanks - I had the same prob and reinstall worked for me also





Mark