Hi,
I want to
make an angled cutout in an assembly.(two parts) in SW 2007
I have two
cylindrical tubes concentric in an assembly that I want to cutout in an angle.
Is there a
way to make the cutout as you would do normally if these parts were one piece?
Because of
the angle it is hard to do it in the edit part mode, and get the cutout lined
out.
I want to
make an angled cutout in an assembly.(two parts) in SW 2007
I have two
cylindrical tubes concentric in an assembly that I want to cutout in an angle.
Is there a
way to make the cutout as you would do normally if these parts were one piece?
Because of
the angle it is hard to do it in the edit part mode, and get the cutout lined
out.