Continue to Site

Welcome to MCAD Central

Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.

loft start/end constraints

TWINTURBOTOM

New member
when using start end constraints between two circular cross sections with no guide curves the start end constraints allow a lot of manipulation.... my question is this....how can I set, say on the start side,contraints for half ofthe cross section? Apply to all I would assum applies the constraint to the whole cross section....when that box is not checked how can I control individual portions of the cross section?? I don't believemovingthe arrows to another location changes theconstraint at just that point with out changing the constraints at the earlier point.....


any help is appreciated...THANKS!!!
 

Sponsor

Articles From 3DCAD World

Back
Top