Hello All:
I am still new to solidworks, so this may be a dumb question. I was wondering if there is a tool, or procedure, where you can setup different cross sections of a piece, as is the foundation for the loft tool, but have those cross sections laid out on a guide curve, such as in the sweep tool.
I really appreciate your help. Thanks!!
I am still new to solidworks, so this may be a dumb question. I was wondering if there is a tool, or procedure, where you can setup different cross sections of a piece, as is the foundation for the loft tool, but have those cross sections laid out on a guide curve, such as in the sweep tool.
I really appreciate your help. Thanks!!