Continue to Site

Welcome to MCAD Central

Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.

Error Showing ( ->? )

bhandel

New member
Hello,


On one of my drawings in Solidworks where I did a sweep, I show Sweep ->? I can't figure out how to fix this. I have done ecerything except for erasing everything below thesweep up to that point to start over. Meaning, I have a ton of cut, sweeps, etc, etc, below this problem that I don't want to erase.


Any help to fix this would be greatly appreciated.


Thank you,


Brandon
 
I think that "->?" means that something in that sketch is defined to something else outside of the sketch. One way to fix this would be to go into the sketch and delete all of the references, and then redefine the sketch.
 

Sponsor

Articles From 3DCAD World

Back
Top