Hi. SW newbie. Tried searching the forum to make sure I'm not repeating a question, didn't see any repeats so I'm throwing this out there even though it's probably a simple answer question....
What I'm trying to do is let the Part Properties (Part Number, Name, Revision, etc) to automatically go into our drawing format when you start a drawing rather than have to manually enter it each time. I can edit our format and get it to read the Part properties, but I'd like to have it do it automatically if possible. Is this something that our document control section could assign to the drawing format once I know how so that it will happen with each drawing or is it a manual task?
Thanks in advance for the help.
What I'm trying to do is let the Part Properties (Part Number, Name, Revision, etc) to automatically go into our drawing format when you start a drawing rather than have to manually enter it each time. I can edit our format and get it to read the Part properties, but I'd like to have it do it automatically if possible. Is this something that our document control section could assign to the drawing format once I know how so that it will happen with each drawing or is it a manual task?
Thanks in advance for the help.