I have a problem with my Solidworks, probably not a problem, but I want to know what is going on.
When I have anfile open, and then add a part to it, something makes it so that when I go to "view" menu, most of the options are greyed out, as well as a couple of other menus. I am notsure what causes this, but I'm sure that it is simple. At the time, all operations are done, but I can't figure it out, and the manual says nothing.
What am I doing wrong?
When I have anfile open, and then add a part to it, something makes it so that when I go to "view" menu, most of the options are greyed out, as well as a couple of other menus. I am notsure what causes this, but I'm sure that it is simple. At the time, all operations are done, but I can't figure it out, and the manual says nothing.
What am I doing wrong?