tumble2bounce
New member
i have only drawn in 2d- radan & autocad, but now have solidworks.
I'm looking to draw an arrangement of 16 sheet metal panels to form a "ship's funnel" arrangement ( with a sloping top edge: 20 mm gap between each panel). i've tried a couple of approaches but keep being stumped by unfathomable error messages (in solidworks)- how would you do this in solidworks? i'd like to flattern the top panels for manufacture & hope solidworks will help avoid the long hand.
i've been using solidworks for about 2 days. can i draw all 16 panels as a part on one screen the split them?
cheers
[email protected]
I'm looking to draw an arrangement of 16 sheet metal panels to form a "ship's funnel" arrangement ( with a sloping top edge: 20 mm gap between each panel). i've tried a couple of approaches but keep being stumped by unfathomable error messages (in solidworks)- how would you do this in solidworks? i'd like to flattern the top panels for manufacture & hope solidworks will help avoid the long hand.
i've been using solidworks for about 2 days. can i draw all 16 panels as a part on one screen the split them?
cheers
[email protected]