Continue to Site

Welcome to MCAD Central

Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.

Chair cushion question, idd file included

skateboardkid

New member
How should I go about this, I need the curvature from the topof the cushion to seamlessly meet the curvature in the front. Im comfortable with lofts and have over a hundred hours of use so far. if it was a square cushion I could use path and profile, however the cushion is skinnier in the rear and fat up front (width wise) even lofts with guide curves wont seem to work.Its 18" across the rear 28" across the front and 6 inches tall. I need .5 to .75inch of cushion on top, front and bottom, the back of the cushion ismatched with the radius of the back of the chair.


Thanks beforehand..
Edited by: skateboardkid
 
I got it, I had to draw the loft planes at 45 and 135 off from the top and bottom of the cushions. ahh yes it only took my 4 hours of punching buttons
 

Sponsor

Articles From 3DCAD World

Back
Top