Hi.
In lesson 2-assemblies of the "online tutorial" that is built into solidworks 2004, the lesson says to use the "zoom to area" tool and to"drag select"an area of the part-->to turn the "zoom to area" tool off and then to select the front face of the thin wall.
Question 1:
When i click on the "zoom to area" tool and then place my "arrow" [which turns into a circle] over the corner as shown, it results in the picture getting huge---->>>
----Is that what is supposed to happen>
Question 2:
I am supposed to click on "extruded cut" andthen front face of the thin wall wall--->i've been unable to highlight the front face
Hopefully someone will be familiar with what i am talking about and explain it to me.
Thank you in advance
Alex
In lesson 2-assemblies of the "online tutorial" that is built into solidworks 2004, the lesson says to use the "zoom to area" tool and to"drag select"an area of the part-->to turn the "zoom to area" tool off and then to select the front face of the thin wall.
Question 1:
When i click on the "zoom to area" tool and then place my "arrow" [which turns into a circle] over the corner as shown, it results in the picture getting huge---->>>
----Is that what is supposed to happen>
Question 2:
I am supposed to click on "extruded cut" andthen front face of the thin wall wall--->i've been unable to highlight the front face
Hopefully someone will be familiar with what i am talking about and explain it to me.
Thank you in advance
Alex