Hello all,
I'm using SW 2005and would appreciate suggestions on how to include an isometric view of a sheetmetal part in a drawing that contains the model's flat state. I looked all over the Help file but couldn't find anything about this.
Here are the details: I created a new drawing with two views of the model's flat state; when Itry to include a new drawing view I'm giventheusualoptions (default orientations, default views, and flat state), but cannot include the one I want - i.e. the isometric view in "unflattened" state.
If I suppress the flat state in the model, then the drawing itself isrebuilt to reflect this change. Seems like I can't have a representation of the two states in the same sheet. Is there a way out?
Thank you in advance for your help and best regards,
Edoardo
I'm using SW 2005and would appreciate suggestions on how to include an isometric view of a sheetmetal part in a drawing that contains the model's flat state. I looked all over the Help file but couldn't find anything about this.
Here are the details: I created a new drawing with two views of the model's flat state; when Itry to include a new drawing view I'm giventheusualoptions (default orientations, default views, and flat state), but cannot include the one I want - i.e. the isometric view in "unflattened" state.
If I suppress the flat state in the model, then the drawing itself isrebuilt to reflect this change. Seems like I can't have a representation of the two states in the same sheet. Is there a way out?
Thank you in advance for your help and best regards,
Edoardo