Hi there,
For my company I'd like to introduce the use of smart components (SW 2006) to simplify drawing. Unfortunately I can't find enough information about this in courses and on the internet.
For example: I'd like to make asteel plate with hole series and smart fasteners into a smart component, so that I can insert this into a weldment where then automatically the necessary holes are created and fastener length is adjusted.
Is this possible? And if so, how do I do it? I can only make itwork now with extrusions and such...
For my company I'd like to introduce the use of smart components (SW 2006) to simplify drawing. Unfortunately I can't find enough information about this in courses and on the internet.
For example: I'd like to make asteel plate with hole series and smart fasteners into a smart component, so that I can insert this into a weldment where then automatically the necessary holes are created and fastener length is adjusted.
Is this possible? And if so, how do I do it? I can only make itwork now with extrusions and such...