I have several solid parts for which I need to create 2-D dimensioned
drawings. The parts differ in small details, but are otherwise quite
similar. I did not use configurations to create the files because my
MasterCAM programmer has issues with extracting different solids from a
drawig with configurations. Instead I make one sldprt for each unique
piece and he imports each of them into MasterCAM directly.
I now have a nicely (for me anyway) dimensioned drawing of one of these
parts. If I could just change the name of the file referenced by the
drawing file I could presumably create a nearly identical drawing with
the new dimensions. After all, if I make a change to the referenced
model, the drawing updates itself just fine.
Any ideas about how I might do this?
Thanks,
Jim
drawings. The parts differ in small details, but are otherwise quite
similar. I did not use configurations to create the files because my
MasterCAM programmer has issues with extracting different solids from a
drawig with configurations. Instead I make one sldprt for each unique
piece and he imports each of them into MasterCAM directly.
I now have a nicely (for me anyway) dimensioned drawing of one of these
parts. If I could just change the name of the file referenced by the
drawing file I could presumably create a nearly identical drawing with
the new dimensions. After all, if I make a change to the referenced
model, the drawing updates itself just fine.
Any ideas about how I might do this?
Thanks,
Jim