Delinquent
New member
I'm trying to loft a surface from 2 sketched curves. That works fine, nowI want to refine it a bit using a guide curve to shape the loft.
I have created a plane to sketch the guide curve on, but I cant get the ends of the guide curve to hit either of the curves I am lofting - I think I have but when I look at it 3D the ends are floating in mid air, meaning I just get an error every time I try and loft. Am I missing something really obvious here?! Is there not some simple way to make sure the guide spline snaps to the point where the sketch curves to be lofted intersect the plane of the guide curve?
This is in SW 2004 BTW.
Many Thanks!
I have created a plane to sketch the guide curve on, but I cant get the ends of the guide curve to hit either of the curves I am lofting - I think I have but when I look at it 3D the ends are floating in mid air, meaning I just get an error every time I try and loft. Am I missing something really obvious here?! Is there not some simple way to make sure the guide spline snaps to the point where the sketch curves to be lofted intersect the plane of the guide curve?
This is in SW 2004 BTW.
Many Thanks!