Hi all,
I am modeling a mini baja car frame that is made from 1.25" dia tubing with a wall thickness of .065". So far, I've completed the entire sketch using 3d sketching. That working pretty well. My intent was to go back and sweep the cross section of the tubing to create the 3d. That works well enough on the closed loop sections of the sketch, but anywhere I sketched just a chain, rather than a loop, I can't sweep the profile. Any suggestions woudl be greatly appreciated.
Thanks
I am modeling a mini baja car frame that is made from 1.25" dia tubing with a wall thickness of .065". So far, I've completed the entire sketch using 3d sketching. That working pretty well. My intent was to go back and sweep the cross section of the tubing to create the 3d. That works well enough on the closed loop sections of the sketch, but anywhere I sketched just a chain, rather than a loop, I can't sweep the profile. Any suggestions woudl be greatly appreciated.
Thanks