Continue to Site

Welcome to MCAD Central

Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.

detail view of a bent cable

SAEID BEZIAN

New member
Hi Everyone!


I am having problem printing a detail view of a bent cable.


Print out is screwed up and bent is not shown as it is.


There is a disconnection on the bend and show up like a circle.


I appreciate any answer on this issue.


Saeid Bezian


Mechanical Designer


Sinclair Technologies Inc.


Aurora,Ontario,Canada
 
Hi Saeid


I am not sure if this will help but when I encountered problems with missinglines in drawings I would zoom in and highlight the feature (it will usually show up purple) I then left click it (should turn green) then go to sketch scroll down and click convert entities. You might have to trim the line a bit to get it to fit in your drawing but usually that takes care of missing lines. I had to do this quite a bit when cross hatching sections of Isometric views.Sometimes changing the view just a little will make them show up too. Hope this helps. Good luck


smiley1.gif
 

Sponsor

Articles From 3DCAD World

Back
Top