Tables?

How does one create a data table in SW 2004? Can you use Excel to do
this? If so, how is this accomplished? I was able to create and insert
an Excel Worksheet into my drawing, my only problem now is that I see
the whole sheet, even the cells that don't have any data? I was hoping
to just insert the filled in cells. In the Excel document I set my
print area to no avail.

Any suggestions? Or is there a better method?

Ive seen something like this before, What I have done in the past is place the excel sheet on the drawing. When you are in the drawing r-click and select edit in worksheet. when is excel size the border of the excel doc so you can see all the cells. save the document and go back to the drawing. When back to the drawing it may update. If not do a ctrl q which is a forced rebuild.


Hope this helps