PDA

View Full Version : Routing and Flattening Ribbon Cables



jstone
10-07-2011, 09:15 PM
I am looking to flatten a ribbon cable. When routing the ribbon cable, it appears you have to start at a singleentry portin the center of the connector and then attach to a network following pin 1. I can get the cable modeled this way. When I flatten, the center location attaches to conductor 1 and the connector is offset from the cable??


Has anyone been succesful with ribbon cables and can give some pointers?


Wildfire 4


Creo Schematics 1


Thanks,


jef



Edited by: jstone