Not sure if this is a routed or an assembly question. I got an assembly with wiring that I am using in a procees for assydrawing. Some of the wiring is routed thru a deck plate to connections in a couple of batteries.
So Iedited the definition of the deckplateso that I could make a family table to show the deck plate up at 90 deg for the process step that connects the batties.except fortwo independent references it workedas planned.
I now have a generic with the deck plate in finnal position and an instance with the deckplate at90 degrees.My problem is with the generic, all wiring ispositioned corect except for one harness that is still at the 90 degrees (see zipped picture).I opened the harness it self and tried to regenerate but did not fix it. Any ideas on how to fix it? or what I did wrong?
2009-05-07_114126_pic_01.zip
later Jim
So Iedited the definition of the deckplateso that I could make a family table to show the deck plate up at 90 deg for the process step that connects the batties.except fortwo independent references it workedas planned.
I now have a generic with the deck plate in finnal position and an instance with the deckplate at90 degrees.My problem is with the generic, all wiring ispositioned corect except for one harness that is still at the 90 degrees (see zipped picture).I opened the harness it self and tried to regenerate but did not fix it. Any ideas on how to fix it? or what I did wrong?
2009-05-07_114126_pic_01.zip
later Jim