wildfire 4 and intralink 3.4

we intend to work with wildfire 4 and intralink 3.4. we would like to learn from any one who already work with those two.


miki raz
cadsupport engineer
rafael

I know that it works with intralink 3.4. However I m not sure what date code you have to have.

Will WF4 work with 3.4 M30?


Edited by: Heathbn

Intralink 3.4 M61 is the correct build for WF4. It is working good and is supported by PTC.

we use Intralink 3.4 M060 with WF4 M030 ..so far so good..


only problem is that the duplicate option in intralink 3.2 or 3.3 is not the same in 3.4.


If we have copy geometry references from assembly or another part, then it will ask you to duplicate that source of the copy geom.