Mold core and cavity for a bottle

• Oct 23, 2008

• #1

V

varadinum

New member

I have some hard time to try to design a mold core and
cavity for a bottle. Can anyone help me with this issue.
Thank you very much.
Edited by: varadinum

 

• Oct 23, 2008

• #2

Zaki

Member

Please upload the part here so I can check it or do it if necessary. Just post the part file

 

• Oct 24, 2008

• #3

V

varadinum

New member

Zaki,

Thank you very much for your promote response. This is
the first time I am using this forum, so apologize for
any mistake I will do.

 

• Oct 24, 2008

• #4

Zaki

Member

Did you learned the mold designing??? then why you get hard time for just a simplest mold man. It must not needed a core for this, only two cavities. Its an extrusion blow part, or may be strech blow or injection blow. But core is not needed in anycase. Just wait, I will post pictures of mold after a while.

 

• Oct 24, 2008

• #5

Zaki

Member

Hi Dear
please check the mold. this is the way to design a basic extrusion blow mold.


2008-10-24_032459_bottle.mfg.part1.rar

2008-10-24_032523_bottle.mfg.part2.rar

2008-10-24_032535_bottle.mfg.part3.rar

 

• Oct 24, 2008

• #6

V

varadinum

New member

Hi Zaki,


For some reasons I cannot open the .mfg and .asm files. Can you help me with this issue?

 

• Oct 25, 2008

• #7

Zaki

Member

which version you are working on?? these are made in wildfire2. did you downloaded these files properly?

 

• Oct 25, 2008

• #8

V

varadinum

New member

Hi Zaki,
I am using W3.0 so maybe that