tolrence_table

hii...


i am harish, i am using wf 2.0,well i am facing problem in the tolerence table, i.e


i am not getting the hole and shaft features in the dim. properties table , pls help me.





thax in adavance,


Harish.p

Probably, your part was created as empty part and not with template start part. But, you can import tolerance tables into the part later. To do that:

1. Click #Edit, #Setup, #Tol Setup.
2. Click #Tol Tables, then #Retrieve and select all the tolerance table, you want to use in part.
3. All "DONE".

Now you should be able to set the tolerance classes for Hole/Shaft features.

If that is not the case, i.e. part was created with template start part, check if config.pro options for tolerances are correctly set.

Dear Harish,


Have a look at this link too.


[url]http://www.mcadcentral.com/proe/forum/forum_posts.asp?TID=33 623&KW=HOLE+BASIS[/url]


Further,a search of the forum will give you the answers to most problems and could be faster.