We are a school which has been graced with the good fortune of Pro-E and a Z-corp Rapid Prototype machine. We use the Cell Phone tutorial as our primary tool for beguinning students to learn to use Pro-E and it is also the practice printout for the 3-D Printer.
The problem we have is that the keypad does not fit into the front cover; To make the holes for the keys, it uses the Cut Out feature. Some others and I from our school have attempted to find a way to add a tolerance to the Cut Out to make it easier for the keypad model to slide in. As of yet we have found nothing; The solution we are currently using is one we made up in which we create a keypad with larger keys and use it to cut out, then we revert to the smaller keypad while still referencing the larger one. This is cumbersome, and it confuses many of the students. Any better suggestions would be very helpful; We have just gotten the driver working for the RP Machine, and will start running it for the classes on monday.
The problem we have is that the keypad does not fit into the front cover; To make the holes for the keys, it uses the Cut Out feature. Some others and I from our school have attempted to find a way to add a tolerance to the Cut Out to make it easier for the keypad model to slide in. As of yet we have found nothing; The solution we are currently using is one we made up in which we create a keypad with larger keys and use it to cut out, then we revert to the smaller keypad while still referencing the larger one. This is cumbersome, and it confuses many of the students. Any better suggestions would be very helpful; We have just gotten the driver working for the RP Machine, and will start running it for the classes on monday.