Hi All,
Using WF3.
Is there a way to write a relation to pick between 2 features? I have a part which can either have a certain cut one way or have a different cut based on it's use.
I was thinking of using a if else statement and a parameter. This would then set the family table to turn each feature on or off.
Jeff Toff
Using WF3.
Is there a way to write a relation to pick between 2 features? I have a part which can either have a certain cut one way or have a different cut based on it's use.
I was thinking of using a if else statement and a parameter. This would then set the family table to turn each feature on or off.
Jeff Toff