How to place a pattern within a fam table

• Jul 9, 2007

• #1

S

sjballen

New member

I have a generic part that has a pattern of 4 tapped holes. This will be a feature of some parts that I have within a family table. When I add this feature to the family table it appears to work fine. There are no errors when I verify the instances. However, when I open an instance with the pattern it is not there. It does not show up in the model tree at all. Any ideas?


SJB

 

• Jul 9, 2007

• #2

T

trillicomm

New member

zip the file and upload it so we can look

 

• Jul 9, 2007

• #3

S

sjballen

New member

2007-07-09_150638_pattern_problem.zip

 

• Jul 9, 2007

• #4

T

trillicomm

New member

try again

 

• Jul 9, 2007

• #5

S

sjballen

New member

2007-07-09_151117_pattern_problem.zip


I hope it works.

 

• Jul 9, 2007

• #6

T

trillicomm

New member

Feature HSING_CO is set to NO in the table. Your bolt pattern depends on that feature.

Set to YES, then verify it. Some instances fail, some don't.


Edited by: trillicomm

 

• Jul 9, 2007

• #7

S

sjballen

New member

I don't see that. It appears to me to be dependant on OS_CUTOUT. When I changed HSING_CO to yes the part failed. I used the last instance in the family table.

 

• Jul 9, 2007

• #8

T

trillicomm

New member

that last one failed

try the second to last, it works. SK30-0516-0EC


Edited by: trillicomm

 

• Jul 9, 2007

• #9

T

trillicomm

New member

the last instance failed because the placement of Edge F12 is lost.

just redefine (twice) it will be ok.