Hello
As an absolute beginner in Pro Engineer I am trying to create an ellisoid (3D) where all the three semi-principal axes are different in length.
Probably this starts with creating a sphere and then scaling it differently in two orthogonal directions.
However, after creation of the sphere (from a half-circle rotated about its axis; maybe this can be done simpler) I do not get it how to scale the sphere.
Finally this ellipsoid should be empty (i.e. not filled), since it should be imported by Mastercam.
I am happy for every idea of how to tackle this! Thanx!
bach
As an absolute beginner in Pro Engineer I am trying to create an ellisoid (3D) where all the three semi-principal axes are different in length.
Probably this starts with creating a sphere and then scaling it differently in two orthogonal directions.
However, after creation of the sphere (from a half-circle rotated about its axis; maybe this can be done simpler) I do not get it how to scale the sphere.
Finally this ellipsoid should be empty (i.e. not filled), since it should be imported by Mastercam.
I am happy for every idea of how to tackle this! Thanx!
bach