There's an option to set the angle and the spacing values default before you create a new xsection in the part:
In Release 20.0, the spacing and angle of cross-hatching in newly created planar and offset cross-sections can be controlled.
To control the display, set the number parameters "default_xhatch_spacing" and "default_xhatch_angle"
using the SETUP menu or the RELATIONS menu.
These two parameters are not predefined in Pro/ENGINEER. To create them, select #Setup, #Parameters, #Part, #Create, #Real_number and enter the parameter name and its value :
For example, enter "default_xhatch_spacing" and set it to 5; then enter "default_xhatch_angle" and set it to 30.
The parameter units is depending to length unit for the spacing and the angle units for the angle.
These parameters only affect new cross-sections.
This solutionworks only with the anglevalues, spacing values don't know why, but doesn't work in any proe versions.
Tried in:
proe 2001 2005030
proe wf2 m171
proe wf2 m250
any idea?
In Release 20.0, the spacing and angle of cross-hatching in newly created planar and offset cross-sections can be controlled.
To control the display, set the number parameters "default_xhatch_spacing" and "default_xhatch_angle"
using the SETUP menu or the RELATIONS menu.
These two parameters are not predefined in Pro/ENGINEER. To create them, select #Setup, #Parameters, #Part, #Create, #Real_number and enter the parameter name and its value :
For example, enter "default_xhatch_spacing" and set it to 5; then enter "default_xhatch_angle" and set it to 30.
The parameter units is depending to length unit for the spacing and the angle units for the angle.
These parameters only affect new cross-sections.
This solutionworks only with the anglevalues, spacing values don't know why, but doesn't work in any proe versions.
Tried in:
proe 2001 2005030
proe wf2 m171
proe wf2 m250
any idea?