Continue to Site

Welcome to MCAD Central

Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.

Formed In Assembly, Flat In Drawing

maesoph

New member
Dear All:


I have a cone shaped part that needs to be cone shaped in the assembly, but shown as a flat pattern in any drawings of it that are made. How can I do both??????
 
Create the cone shaped part, then create a falt pattern of it.


Bring the cone-shaped instance into your assembly, use the flat pattern in your drawing.
 
I may not fully understand.. I have the flat pattern made and then made simplified reps for each state and am able to bring in the cone to my assembly and install just fine, but when I close and re-open, it goes back to the flat pattern.
 
Create an instance to show the flat state and use the generic (cone shaped)in assembly.And show the instance in the drawing.
 

Sponsor

Articles From 3DCAD World

Back
Top