Hi cad users,
I know that creating sheetmetal from flat sheet is not a good approached.
However, sometimes , we may need to do so esp. for existing parts
which are already in production.
However, i am having problem of determining the bending line position in order to
create the correct bended part. If i set the K-factor to 0.5, is that means that the bending line should always be position in the middle of the bending area?
Anybody expert in this? Can share the tips with me?
I know that creating sheetmetal from flat sheet is not a good approached.
However, sometimes , we may need to do so esp. for existing parts
which are already in production.
However, i am having problem of determining the bending line position in order to
create the correct bended part. If i set the K-factor to 0.5, is that means that the bending line should always be position in the middle of the bending area?
Anybody expert in this? Can share the tips with me?