Sorry if my explanation is unclear, I'm new to this:
I'm trying tocreate a table that is referenced to my family table. I referenced it by using &d# for the dimension. The problem is that I would like it to be in fraction format. I tried PTC Support and the only solution I could get out of that was very complex. I was wondering if anyone new of a moresimple was of converting the decimal parameter to a fractional parameter.
Hopefully this description is clear, if not I'll try to reword or be more specific.
Thanks in advanceto anyone that takes time to help me out.
I'm trying tocreate a table that is referenced to my family table. I referenced it by using &d# for the dimension. The problem is that I would like it to be in fraction format. I tried PTC Support and the only solution I could get out of that was very complex. I was wondering if anyone new of a moresimple was of converting the decimal parameter to a fractional parameter.
Hopefully this description is clear, if not I'll try to reword or be more specific.
Thanks in advanceto anyone that takes time to help me out.