I recently discovered a bug in WF3 when using the new sheet metal
flange tool. If you add a flange feature, and then edit
Pro/Program, a line in the flange feature is interpreted as an "ADD
FEATURE" and Pro/Program gives you an error. The workaround is to
edit the failed program and delete all lines looking something like
this:
14.1 Add Miter Cuts Yes
By removing them, the program will accept your changes and allow you to continue on.
I have spoken to tech support and have been informed this will probably not be fixed until WF4, so this is the only workaround.
I hope this saves someone some trouble.
Jim
flange tool. If you add a flange feature, and then edit
Pro/Program, a line in the flange feature is interpreted as an "ADD
FEATURE" and Pro/Program gives you an error. The workaround is to
edit the failed program and delete all lines looking something like
this:
14.1 Add Miter Cuts Yes
By removing them, the program will accept your changes and allow you to continue on.
I have spoken to tech support and have been informed this will probably not be fixed until WF4, so this is the only workaround.
I hope this saves someone some trouble.
Jim