Hi all,
I need some help with understanding the Layouts. From what I've researched so far I understand it helps out in top-down assembly design and basically all it has are place holders which can be 'filled' in later. But I'd like to learn a bit more, may be with an example layout or something, how to start with one and translate that into a real assembly etc., I will be searching PTC's knowledge base, but I thought I'd have better luck over here. I'd appreciate any help just to point me in the right direction.
Thanks folks!
PS: I don't know if this is the right forum topic to ask my question about layouts. If this is not, I request the mods to move it to the right one. Thanks!
Edited by: anandel
I need some help with understanding the Layouts. From what I've researched so far I understand it helps out in top-down assembly design and basically all it has are place holders which can be 'filled' in later. But I'd like to learn a bit more, may be with an example layout or something, how to start with one and translate that into a real assembly etc., I will be searching PTC's knowledge base, but I thought I'd have better luck over here. I'd appreciate any help just to point me in the right direction.
Thanks folks!
PS: I don't know if this is the right forum topic to ask my question about layouts. If this is not, I request the mods to move it to the right one. Thanks!
Edited by: anandel