Monkeyboy62
New member
Hi all
I have created a simulation of two moulds opening pivoting about an axis but can only get one half to open. I have two snapshots one with both moulds closed and one with both opening but when I run the analysis one one half moves? Can one servo motor be used to open both components? or do I need two one for each , if so how do I do this as I thought you could only have one servo motor at a time.
any help please
many thanks
Monkeyboy
I have created a simulation of two moulds opening pivoting about an axis but can only get one half to open. I have two snapshots one with both moulds closed and one with both opening but when I run the analysis one one half moves? Can one servo motor be used to open both components? or do I need two one for each , if so how do I do this as I thought you could only have one servo motor at a time.
any help please
many thanks
Monkeyboy